Typical published 2026 prices put raised boarding on legs at about £80 to £100 per square metre, and boards laid straight onto the joists at £55 to £70 per square metre. Most standard jobs cost between £500 and £1,500. A raised system is usually the right choice where the insulation sits above the joist tops, so the boards do not squash it.
Raised boarding or boards on the joists
There are two main ways to board a loft for storage. The right method depends on how thick your insulation is compared with the joists. Most ceiling joists are only around 100mm deep.
Direct boarding involves screwing wooden boards straight into the existing timbers. This method is cheaper. It only suits a loft where the insulation sits below the joist tops. If your insulation is higher than the wood, laying boards directly on top will crush the material.
Raised boarding uses loft legs to lift the floor above the insulation. Loft legs are plastic or metal supports fixed to the tops of the joists. They are usually 175mm or 300mm tall. The boards are then screwed into the top of these legs. A raised boarding system is usually the right choice where the insulation sits above the joist tops, because it protects the insulation below.
What size of loft changes the price
Builders price loft boarding based on the floor area and the method they use. The table below shows typical costs for different loft sizes.
|
Loft area |
Typical cost |
|---|---|
|
15 square metres |
£1,100 to £1,500 |
|
20 square metres |
£1,500 to £1,800 |
|
30 square metres |
£2,350 to £2,500 |
|
40 square metres |
£3,000 to £3,250 |
These figures are typical published prices for 2026, and real quotes depend on the size of the loft, the method and access.
Labour is a large share of any job. The typical labour day rate is £150 to £250, and this is higher in London and the South East. If your current timbers are uneven, undersized or damaged, you may need joist strengthening before any boards go down. Strengthening is put at £200 to £600, and it is a job for a tradesperson, not for you.
Estimates vary: another set of 2026 prices puts raised boarding at £75 to £100 per square metre and direct boarding at £60 to £80. The table below shows the expected totals from this second set of figures.
|
Loft area |
Typical cost |
|---|---|
|
About 6 square metres |
£700 to £1,000 |
|
10 to 12 square metres |
£900 to £1,450 |
|
15 square metres |
£1,100 to £1,500 |
|
20 square metres |
£1,500 to £2,000 |
|
40 square metres |
£3,000 to £4,000 |
These are also typical published prices for 2026, and real quotes will differ. Some firms quote before VAT at 20 per cent, so always ask which figure you are looking at.
Why insulation depth matters when boarding
The commonly recommended depth is at least 270mm of mineral wool in a loft. Because most ceiling joists are much shallower than this, the mineral wool naturally spills over the top of the timber.
Squashing insulation to fit under boards means squashed insulation keeps much less heat in. By using a raised system on loft legs, you allow the mineral wool to sit at its full depth.
A raised floor also leaves a small gap between the insulation and the boards. This small gap helps prevent condensation from forming on the underside of the wood.
How much weight can loft joists take
The joists were designed to hold up the plasterboard ceiling below, not to work as a floor. They may not be strong enough to carry heavy loads.
Many newer homes are designed for light storage of around 25kg per square metre. You should spread loads evenly across the floor and avoid stacking heavy boxes in one spot.
Heavier storage needs a tradesperson's advice on joist strengthening and heavier boards. If you plan to store heavy items, ask a tradesperson for advice before you board. Do not attempt structural work yourself.
Do you need building regulations to board a loft
Planning permission and building regulations are two separate systems. Many projects need one, both or neither. Ask your council to confirm what applies to your own project.
Building regulations approval is needed for extensions, loft conversions and most structural and services work. According to the Planning Portal, "Building regulations approval is required to convert a loft or attic into a liveable space." Adding a bed, desk or sleeping space turns your storage project into a conversion.
If you are only creating a storage area, the Planning Portal says, "If you decide to lay flooring boards over the existing joists in the loft space, then you may need to apply to a building control body for building regulations approval." Always check with your local council building control team before you start work.
For a full conversion, the Planning Portal explains that the regulations will be applied to ensure, for example, that the structural strength of the new floor is sufficient, the stability of the structure including the existing roof is not endangered, there is safe escape from fire, stairs to the new floor are safely designed, and there is reasonable sound insulation between the conversion and the rooms below. You can find more detail on this in the guide to fire safety rules for loft conversions.
Building regulations approval comes from council building control or a registered building control approver, or through a competent person scheme for certain trades. The completion certificate matters when selling. Councils can now take enforcement action for up to ten years. Scotland and Northern Ireland have their own systems, so check locally if you live there.
Safety and hidden rules in the loft space
Lofts are full of hazards. If you step between the joists, you can fall through the fragile plasterboard ceiling, so never walk off the joists. Older roofs can also hide dangerous materials. Houses built or refurbished before 2000 may contain asbestos, which must be dealt with by competent people. Never attempt to remove or disturb asbestos yourself.
Many lofts house water tanks, plumbing pipes and exposed wiring. You must use a qualified tradesperson for any work near wiring, tanks or flues. Electrical work needs a registered electrician, and gas work needs a Gas Safe registered engineer. Confirm their membership on the scheme's own register and treat it as a good sign, not a guarantee.
Under the CDM Regulations 2015 a domestic client's health and safety duties normally pass to the builder. Lofts also involve work at height, so leave the work to a tradesperson.
If any work affects a shared wall or boundary, the Party Wall etc. Act 1996 may apply in England and Wales, so ask your council.
What a loft boarding quote should include
A proper project starts with drawings (visual plans of the work) and a specification (a detailed list of materials and standards). Even for a small loft, you need a written contract. A quote is fixed and an estimate is not.
Loft boarding may be done by a general builder or main contractor, who may bring in subcontractors for specialist work. Boarding is much simpler than a full loft conversion.
Your written quote should cover:
- Whether the boards are direct or raised, and the height of any loft legs.
- The exact floor area to be boarded.
- A schedule of works (a timetable showing what happens when).
- Any advice from a structural engineer or tradesperson if you plan heavy storage.
- Provisional sums (allowances for things that cannot be priced yet) for anything found once the loft is opened up.
- Stage payments (paying in chunks as work progresses) and a final payment on completion (the last sum paid when all is finished).
Always hold back a contingency (a backup fund for unexpected costs) to cover variations (changes after the price is agreed). Never pay the final balance until you have finished snagging (finding and fixing minor faults at the end of the job).
Under the Consumer Rights Act 2015, you are entitled to work done with reasonable care and skill, for a reasonable price and within a reasonable time where none was agreed. You have a 14-day cooling-off period for contracts agreed at home, by phone or online. Section 75 protection applies to credit card payments. If things go wrong, Citizens Advice is the signpost for disputes.
To find reliable tradespeople, you can look for members of the Federation of Master Builders, which vets and independently inspects members. You can also look for TrustMark, which is the government-endorsed quality scheme.
Common mistakes when boarding a loft
Many people make errors that damage their home or waste their money. Avoid these common traps:
- Choosing a builder on price alone.
- Starting without drawings, a specification or a written contract.
- Handing over large cash deposits before any work begins.
- Accepting an estimate as if it were a quote.
- Changing the design mid-build without agreeing the cost in writing.
- Being told building regulations are not needed without checking with your council first.
- Accepting cash deals offered without VAT or paperwork.
- Not telling the home insurer about the project.
- Paying the final instalment before snagging and certificates are done.
- Hiring cowboy builders who take on more jobs than they can staff.
Common questions
How do loft boarding stilts work?
Loft legs or stilts are plastic or metal supports that screw directly into your ceiling joists. The wooden floorboards are then fixed to the top of these legs. This creates a raised platform that leaves enough room for thick insulation underneath.
Can you put heavy boxes on loft boards?
Many newer homes are designed for light storage of around 25kg per square metre. Heavy items can exceed this. If you want to store heavy items, you must get professional advice on strengthening the timbers.
What happens if you squash loft insulation?
Squashed insulation keeps much less heat in. A small gap between the insulation and the boards also helps prevent condensation.
When does boarding a loft turn into a conversion?
It becomes a conversion when you create a liveable space, such as adding a bed, a desk or sleeping space. A conversion requires full building regulations approval to check the structural strength, fire safety, stairs and sound insulation. You can read more about full room projects in the guide to loft conversion costs.
What to do next
Before you hire anyone to board your loft, you should get your plans in order and check the rules.
- Measure the area you want to board and check the depth of your current insulation.
- Ask your local council building control team if your specific storage plans need approval.
- Get three written quotes against the same specification from local tradespeople.
- Ask to see finished examples of their previous loft boarding jobs.
- Check their proof of insurance and ensure they offer a written contract.
- Agree a payment plan tied to progress, keeping a final amount back until snagging is finished.
Taking the time to compare prices and methods helps you get a safe, usable storage space. When you are ready to get quotes, you can find a builder near you to look at your joists and price the work.
Find a top rated builder near you
3,554 builders across the UK, each ranked on their Google rating and the number of reviews behind it. Start with your county: